Moulds - Services

DESIGN

Our engineering department collaborates closely with customers in developing the part, providing solutions to improve the mold performance and quality of the part.

 

TECHNOLOGICAL TESTING CENTRE

In order to improve the performance of the mold and obtain the minimum work cycle, many resources are devoted to research and development, such as the improvement of hot runners, cooling circuits, or the choice of materials and adequate surface treatment.

At the customer's request, and thanks to our state-of-the-art machinery, we are able to produce pre-series which allow us to control the mols performance for a longer period of time.

At our technological center, we test all molds and carry out the set up.

The high quality of our machines, as well as a comprehensive cooling system, enable us to thorouglhly verify all injection parameters, work cycles,... agreed with the customer.

SPECIAL PROJECTS

Our facilities are prepared to rapidly receive and adapt an injection machine, and peripheral robots provided by our customer, in order to put the mold and the production process ready.

The company's philosophy is based on offering our customers integral solutions with automated processes, in order to optimize the production system and meet their needs.

PROTOTYPES

We develop prototype molds of a cavity, on which we apply the same technology as in industrial molds so as to simulate the performance, tolerances and finishes of the production  mold as accurately as possible.

TECHNICAL ADVISING

At our technological centre, we test and set up all our molds. The quality of our machinery, as well as a complete cooling system enable us to verify comprehensively all injection parameters, work cycles and other aspects agreed with our customers.

(+34) 972 70 03 58 info@matrix-sa.com

Address

Ctra. C-26, km 195 17500 Ripoll (Girona)

GPS: 42º 13' 7.74" N - 2º 12' 42.80" E

Contact

T. (+34) 972 70 03 58

F. (+34) 972 70 33 51

Share content

Legal

Legal